PRTG Manual: SNMP NetApp Network Interface Sensor
The SNMP NetApp Network Interface sensor monitors a network adapter of a NetApp storage system via the Simple Network Management Protocol (SNMP).
For a detailed list and descriptions of the channels that this sensor can show, see section Channel List.
- Dutch: SNMP NetApp Network Interface
- French: NetApp interface réseau (SNMP)
- German: SNMP NetApp Netzwerkschnittstelle
- Japanese: SNMP NetApp ネットワークインターフェース
- Portuguese: Interface de rede NetApp (SNMP)
- Russian: Сетевой интерфейс NetApp по SNMP
- Simplified Chinese: SNMP NetApp 网络接口
- Spanish: Interfaz de red NetApp (SNMP)
Consider the following remarks and requirements for this sensor:
Remark |
Description |
---|---|
NetApp versions |
This sensor only supports NetApp versions up to 8.2. |
IPv6 |
This sensor supports IPv6. |
Performance impact |
This sensor has a low performance impact. |
NetApp NIC |
If you use NetApp cDOT 8.3 or NetApp ONTAP as of version 9.0, we recommend that you use the NetApp NIC sensor. |
The sensor has the following default tags that are automatically predefined in the sensor's settings when you add the sensor:
- netapp
- snmpnetapp
- snmpnetappnetworkinterfacesensor
For more information about basic sensor settings, see section Sensor Settings.
NetApp Network Interface Settings
Setting |
Description |
---|---|
Network Interface |
The name of the network interface that this sensor monitors. |
Setting |
Description |
---|---|
Primary Channel |
Select a channel from the list to define it as the primary channel. In the device tree, PRTG displays the last value of the primary channel below the sensor's name. The available options depend on what channels are available for this sensor. You can set a different primary channel later by clicking below a channel gauge on the sensor's Overview tab. |
Graph Type |
Define how this sensor shows different channels:
|
Stack Unit |
This setting is only visible if you select Stack channels on top of each other above. Select a unit from the list. PRTG stacks all channels with this unit on top of each other. By default, you cannot exclude single channels from stacking if they use the selected unit. However, there is an advanced procedure to do so. |
By default, all of these settings are inherited from objects that are higher in the hierarchy. We recommend that you change them centrally in the root group settings if necessary. To change a setting for this object only, click under the corresponding setting name to disable the inheritance and to display its options.
For more information, see section Inheritance of Settings.
Which channels the sensor actually shows might depend on the target device, the available components, and the sensor setup.
Channel |
Description |
---|---|
Downtime |
In the channel table on the Overview tab, this channel never shows any values. PRTG uses this channel in graphs and reports to show the amount of time in which the sensor was in the Down status |
Errors In |
The number of incoming errors |
Errors Out |
The number of outgoing errors |
Traffic In |
The incoming traffic This channel is the primary channel by default. |
Traffic Out |
The outgoing traffic |
KNOWLEDGE BASE
What security features does PRTG include?
My SNMP sensors don’t work. What can I do?