PRTG Manual: SNMP Cisco CBQoS Sensor
The SNMP Cisco CBQoS sensor monitors network parameters using Cisco's Class Based Quality of Service (CBQoS) via the Simple Network Management Protocol (SNMP).
The sensor supports the classes Class Map, Match Statement, and Queueing.
For a detailed list and descriptions of the channels that this sensor can show, see section Channel List.
- Dutch: SNMP Cisco CBQoS
- French: Cisco CBQoS (SNMP)
- German: SNMP Cisco CBQoS
- Japanese: SNMP Cisco CBQoS
- Portuguese: CBQoS Cisco (SNMP)
- Russian: SNMP Cisco CBQoS
- Simplified Chinese: SNMP Cisco CBQoS
- Spanish: CBQoS Cisco (SNMP)
Consider the following remarks and requirements for this sensor:
Remark |
Description |
---|---|
IPv4 |
This sensor only supports IPv4. |
Performance impact |
This sensor has a very low performance impact. |
The sensor has the following default tags that are automatically predefined in the sensor's settings when you add the sensor:
- cbqossensor
For more information about basic sensor settings, see section Sensor Settings.
Setting |
Description |
---|---|
Object Type |
The object type of the parameter that this sensor monitors. |
Interface |
The interface of the parameter that this sensor monitors. |
Description |
The description of the parameter that this sensor monitors. |
BitMask |
The number of available channels for the parameter that this sensor monitors. |
ObjectID |
The ObjectID of the parameter that this sensor monitors. |
ConfigID |
The ConfigID of the parameter that this sensor monitors. |
Setting |
Description |
---|---|
Primary Channel |
Select a channel from the list to define it as the primary channel. In the device tree, PRTG displays the last value of the primary channel below the sensor's name. The available options depend on what channels are available for this sensor. You can set a different primary channel later by clicking below a channel gauge on the sensor's Overview tab. |
Graph Type |
Define how this sensor shows different channels:
|
Stack Unit |
This setting is only visible if you select Stack channels on top of each other above. Select a unit from the list. PRTG stacks all channels with this unit on top of each other. By default, you cannot exclude single channels from stacking if they use the selected unit. However, there is an advanced procedure to do so. |
By default, all of these settings are inherited from objects that are higher in the hierarchy. We recommend that you change them centrally in the root group settings if necessary. To change a setting for this object only, click under the corresponding setting name to disable the inheritance and to display its options.
For more information, see section Inheritance of Settings.
Which channels the sensor actually shows might depend on the target device, the available components, and the sensor setup.
Channel |
Description |
---|---|
Current Queue Depth |
The current queue depth |
Downtime |
In the channel table on the Overview tab, this channel never shows any values. PRTG uses this channel in graphs and reports to show the amount of time in which the sensor was in the Down status |
Drop Packets |
The number of drop packets |
Drop Size |
The drop size |
Maximum Queue Depth |
The maximum queue depth |
No Buffer Drop Packets |
The number of drop packets without buffer |
Post Policy Size |
The post policy size |
Pre Policy Packets |
The number of pre-policy packets |
Pre Policy Size |
The pre-policy size |
KNOWLEDGE BASE
What security features does PRTG include?
My SNMP sensors don’t work. What can I do?