PRTG Manual: SNMP Cisco System Health Sensor
The SNMP Cisco System Health sensor monitors the system health of a Cisco device via the Simple Network Management Protocol (SNMP).
SNMP Cisco System Health Sensor
For a detailed list and descriptions of the channels that this sensor can show, see section Channel List.
- Dutch: SNMP Cisco Systeemstatus
- French: Cisco état du système (SNMP)
- German: SNMP Cisco Systemzustand
- Japanese: SNMP Cisco システムの正常性
- Portuguese: Saúde do sistema Cisco (SNMP)
- Russian: Работоспособность системы устройства SNMP Cisco
- Simplified Chinese: SNMP Cisco 系统健康状况
- Spanish: Salud de sistema Cisco (SNMP)
Consider the following remarks and requirements for this sensor:
Remark |
Description |
|---|---|
IPv6 |
This sensor supports IPv6. |
Performance impact |
This sensor has a low performance impact. |
Lookups |
This sensor uses lookups to determine the status values of one or more channels. |
Limits |
This sensor has predefined limits for several metrics. |
Additional tags |
SNMP Cisco System Health sensors that are created with the Cisco Device (Generic) device template for auto-discovery can have additional tags. |
Basic Sensor Settings
The sensor has the following default tags that are automatically predefined in the sensor's settings when you add the sensor:
- snmpciscosystemhealthsensor
- systemhealth
For more information about basic sensor settings, see section Sensor Settings.
Cisco System Health Specific
Setting |
Description |
|---|---|
Measurements |
The ID of the measurement that this sensor monitors. |
Debug Options
Setting |
Description |
|---|---|
Result Handling |
Define what PRTG does with the sensor result:
|
This option is not available when the sensor runs on the hosted probe of a PRTG Hosted Monitor instance.
Sensor Display
Setting |
Description |
|---|---|
Primary Channel |
Select a channel from the list to define it as the primary channel. In the device tree, PRTG displays the last value of the primary channel below the sensor's name. The available options depend on what channels are available for this sensor.
|
Graph Type |
Define how this sensor shows different channels:
|
Stack Unit |
This setting is only visible if you select Stack channels on top of each other above. Select a unit from the list. PRTG stacks all channels with this unit on top of each other. By default, you cannot exclude single channels from stacking if they use the selected unit. However, there is an advanced procedure to do so. |
By default, all of these settings are inherited from objects that are higher in the hierarchy. We recommend that you change them centrally in the root group settings if necessary. To change a setting for this object only, click 
under the corresponding setting name to disable the inheritance and to display its options.
For more information, see section Inheritance of Settings.
Which channels the sensor actually shows might depend on the target device, the available components, and the sensor setup.
PRTG creates one sensor per component.
Channel |
Description |
|---|---|
Available Memory [#] |
The available memory |
CPU [#] |
The CPU load (%) |
Downtime |
In the channel table on the Overview tab, this channel never shows any values. PRTG uses this channel in graphs and reports to show the amount of time in which the sensor was in the Down status. |
Fan [#] State |
The fan status
|
Percent Available Memory [#] |
The available memory (%) |
Power Supply [#] |
The power supply status
|
KNOWLEDGE BASE
What security features does PRTG include?
My SNMP sensors don’t work. What can I do?
