PRTG Manual: Cluster Status

On the Cluster Status tab, you can view all cluster nodes.

i_round_blueThis tab is only available if you run PRTG in a failover cluster.

i_round_blueThis documentation refers to an administrator that accesses the PRTG web interface on a master node. Other user accounts, interfaces, or failover nodes might not have all of the options in the way described here. In a cluster, note that failover nodes are read-only by default.

i_podIf 15 minutes (900) seconds have passed since your last credential-based login and you open a setup page from a different setup page, PRTG asks you to enter your credentials again for security reasons. A dialog box appears. Enter your Login Name and Password and click OK to continue.

i_podThis feature is not available in PRTG Hosted Monitor.

The following information is available:

  • Cluster Status: Shows all connected cluster nodes
  • Cluster Log: Shows all log entries for cluster connections
Cluster Status

Cluster Status

Click the Start Maintenance Mode link to put a cluster node in maintenance mode. A cluster node in this mode is still connected to the cluster, but PRTG discards its monitoring results until you click the Stop Maintenance Mode link. You can use this to explicitly exclude a cluster node from monitoring if you know that the monitoring values are not accurate, for example, because you are reconfiguring the server. During maintenance, PRTG displays a cluster node with a transparent color in the overview graphic.

i_round_blueOn the Cluster Status tab, you do not see if your remote probes are connected to failover nodes. Connect to your failover nodes and explicitly check if remote probes are connected, for example, in the device tree of the PRTG web interface on a cluster node.

i_square_cyanFor more information about cluster settings, see section Cluster.

Others

There are some settings that you must define in the PRTG Administration Tool. For more information, see sections: